Grizzly T10024 - Manual (Page 3)

t10024 Wet grinder accessory Kit #2
-3-
Figure 5. Jig disassembled.
the chisel sharpening jig is capable of accurately
sharpening a variety of chisels. the jig must be
assembled and used differently depending on the
tool you are sharpening and the way you want it
to be sharpened.
To assemble the jig for beveled chisels:
1. Completely disassemble the chisel sharpen-
ing jig as shown in Figure 5.
2. reassemble the jig and the jig holder as
shown in Figure 6.
Figure 6. beveled chisel jig assembled.
Jig holder
Chisel sharpening Jig
4. place the assembled jig onto the universal
support, as shown in Figure 8.
5. adjust the grinding angle by sliding the uni-
versal support in or out and by repositioning
the chisel in the jig. once the desired angle is
achieved, tilt the chisel away from the grinding
wheel, then connect the grinder to power and
turn it ON.
6. return the chisel onto the surface of the
wheel. use a firm grip on the chisel, but do not
use heavy pressure against the wheel. move
the chisel back and forth across the surface of
the wheel while grinding to prevent excessive
or uneven wheel wear.
Figure 8. grinding beveled chisels.
To sharpen beveled chisels:
1. disCoNNeCt griNder From poWer!
2. place the universal support in either the verti-
cal or horizontal mounts, depending on the
desired grinding action as described in the
model t10010/t10097 owner's manual.
3. Clamp the chisel (bevel-side down) into the
jig using the knob, as shown in Figure 7.
your exact clamping method may vary slightly
depending on your chisel.
Figure 7. Clamping bevel chisel (2-sided bevel).