Grizzly T10024 - Manual (Page 2)

-2-
t10024 Wet grinder accessory Kit #2
Operations
Stone Dresser
the stone dresser is used to clean the grinding
wheel when it is loaded with metal filings. it can
also be used to adjust the grit of the wheel to
approximately 220 or 1000.
To use the stone dresser:
1. disCoNNeCt griNder From poWer!
2. place the universal support in the vertical
mounts and position it approximately ½"
above the grinding wheel, then tighten both
mounting knobs.
3. Connect the grinder to power and turn it ON.
4. Wearing gloves, carefully place the stone
dresser against the universal support, then
lower it onto the grinding wheel (
Figure 3).
—if you wish to change the grit of the wheel
to approximately 1000 grit, then place the
finer-grained surface against the wheel.
—if you wish to clean the surface of the wheel
or change the grit back to approximately
220 grit, then place the coarse-grained
surface against the wheel.
Universal Sharpening Jig
1. disCoNNeCt griNder From poWer!
2. place the universal support in either the ver-
tical or horizontal mounts, depending on the
desired grinding action as described in the
model t10010/t10097 user manual.
Note: Never place the universal support in
the vertical mounts when using the stropping
wheel. This will result in sharpening against
the rotation direction and will cause damage
to the leather wheel.
3. slide the universal sharpening jig onto the
universal support and thread in the universal
sharpening jig knobs as shown in
Figure 4.
5. press the stone dresser against the grinding
wheel until the desired results are achieved.
turn the grinder
OFF when complete.
Figure 4. universal sharpening jig.
universal
sharpening Jig
4. adjust the grinding/sharpening angle by rais-
ing or lowering the universal support and tilt-
ing the universal sharpening jig as needed.
5. When the desired angle is achieved, tighten
the four knobs, then connect the grinder to
power and turn it
ON.
6. place the workpiece onto the universal sharp-
ening jig, as shown in Figure 4, then slide it
onto the surface of the wheel. use a firm grip
on the workpiece, but do not use heavy pres-
sure against the wheel. be sure to move the
workpiece back and forth across the surface
of the wheel while grinding to prevent exces-
sive wheel wear.
universal sharpening
Jig Knob
universal
support
Figure 3. stone dresser.
stone dresser