Grizzly G0702 - Manual (Page 24)

-22-
Model g0702 (Mfg. since 1/12)
Note: This can be done with the sandpaper
installed, although it is somewhat more pre-
cise if the sandpaper is not installed.
3. loosen the lock levers and adjust the table
angle until it is perfectly perpendicular to the
disc, then tighten the lock levers while hold-
ing the table in place.
4. using a phillips head screwdriver, loosen the
degree scale pointer, index the pointer on 0˚,
and retighten the screw.
5. recheck the scale accuracy with the square.
When the table tilt is set to 90˚, the table should
be positioned perpendicular to the sanding disc
face. if not follow this procedure.
to calibrate the table tilt:
1. diSConnECt MaChinE FroM poWEr!
2. using a try square or machinist’s square, set
one edge on the table surface and the other
against the face of the disc, as shown in
figure 19.
table tilt Calibration
figure 19. Squaring the table.
tilt Scale and
pointer