Grizzly G1028Z/G1029 - Manual (Page 21)

G1028Z/G1029 Dust Collector -19-
SECTION 6: OPERATIONS
Once assembly is complete and adjustments are
done to your satisfaction, you are ready to test run
the machine.
Turn on the power supply at the main panel.
Press the
START button. Make sure that your fin-
ger is poised on the STOP button, just in case
there is a problem. The dust collector should run
smoothly, with little or no vibration or rubbing nois-
es. Strange or unnatural noises should be investi-
gated and corrected before operating the
machine further.
If you cannot easily locate the source of an
unusual noise or vibration, contact our service
department for help.
Test Run
General
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.
Wear safety glasses dur-
ing the entire operations
process. Failure to com-
ply may result in serious
personal injury.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Operating your Model G1028Z/G1029 is simple
and straightforward. Blast gates located at each
of the machines controls the air flow from the
woodworking machine to the dust collector. If a
machine is not being used, keep the blast gate
closed to maintain higher levels of efficiency
throughout the system.
Always wear a dust
mask when operating
your dust collector. This
machine circulates saw-
dust which may cause
allergic reactions or res-
piratory problems.
DO NOT use the dust collector for any other
purpose besides collecting dust from con-
nected woodworking machines. A dust col-
lector should NEVER be used as an air
cleaner. For safest use, wear a dust mask
and use an air cleaner in addition to the
dust collector.