Grizzly G1028Z/G1029 - Manual (Page 14)

-12- G1028Z/G1029 Dust Collector
Figure 6. Mounting collector to brackets.
Collector
The collector attaches to each support bracket.
The inside of the collector is funnel shaped and
directs the air around in a cyclone motion. Make
sure that the inside taper (funnel) is faced down-
ward and the collector inlet faces toward the col-
lector body.
Secure the front support bracket to the collector
with two (2)
5 ⁄
16
"-18 x 3 ⁄
4
" hex bolts provided.
Before securing the rear support bracket to the
collector, line up the upper bag support bracket
bolt holes with the collector support bracket bolt
holes and the collector. Secure with two (2)
5 ⁄
16
"-
18 x 3 ⁄
4
" bolts provided, as shown in Figure 6.
Figure 5. Mounting brackets to base.
Support Brackets
There are two lower collector support brackets
and one upper bag support bracket. Attach the
collector brackets to the top edge of the base
plate using four (4)
5 ⁄
16
"-18 x 1 ⁄
2
" hex bolts provid-
ed, as shown in Figure 5.