Grizzly G0654 - Manual (Page 18)

-16-
Model G0654 (Mfg. Since 9/07)
Assembly
3. Fasten the top plate to the cabinet supports
with the (4) 3 ⁄
8
"-16 x 1" hex bolts, as shown in
figure 9, so the flat side is up and the single
elliptical slot is on the wheel side of the cabi-
net.
To assemble the jointer:
1. Fasten each cabinet support to the mobile
base chassis with a 3 ⁄
8
"-16 x 1" hex bolt,
threading the bolts though the bottom of the
chassis, as shown in
figure 7.
figure 7. Cabinet supports fastened to chassis.
Cabinet
support
Chassis
figure 10. left and right panels installed.
4. secure the left and right panels to the cabinet
supports with (20) #10-24 x 3 ⁄
8
" flange screws,
as shown in figure 10.
Note: The two holes on the left panel below
the dust chute slot should face down. The
right panel should be installed with the two
block holder holes facing up.
figure 9. top plate installed.
2. Fasten the bottom plate to the mobile base
chassis with (8) m6-1 x 12 flange bolts, 6mm
flat washers, and m6-1 hex nuts, as shown in
figure 8.
figure 8. Bottom plate installed.
Bottom
plate
holes
left panel right panel
push
Block
holder
holes
x 20
v-Belt slot
x 4
x 4
x 8