Epson ActionLaser 1600 - Manual (Page 18)

If an LJ4 driver is not available, contact Windows Support at
(206) 637-7098 to obtain a copy. With a modem, you can
obtain the latest Microsoft drivers files from the Microsoft
bulletin board system at (206) 436-6735. Windows drivers
can also be downloaded from CompuServe
®
or GEnie.
®
If
you are not currently a member of CompuServe but would
like to become one, see page 2 of the Reference Guide for a
special membership offer.
Until you receive your copy of the LJ4 driver, use one of the
following drivers, which are listed in order of preference:
LaserJet IIISi
LaserJet IIIP/IIID
LaserJet III
If none of these drivers is available, you can use any other
LaserJet driver; be aware, however, that some features,
including 600-dpi resolution and certain font families, are
not accessible unless you are using an LJ4 driver or the
ActionLaser 1600 driver.
If you are using the ESC/P2, FX, or GL/2 emulation, see
Chapter 5, “Using Other Printer Emulations,” in the
Reference Guide for information about which driver to use.
5. Choose the install button.
If the driver is already installed on the hard disk, skip to
step 7. If the driver is not installed on the hard disk, a
dialog box prompts you for the pathname.
6. Enter the appropriate path name of the driver and, if
necessary, insert the diskette that contains the driver into a
floppy drive. Choose the OK button.
7. Choose the Set to Default Printer button.
8. If you have no more changes, close the Printers dialog box.