Epson ActionLaser 1600 - Manual (Page 14)

4.
5.
Fasten the other end of the cable to your computer.
For the parallel connector, squeeze the wire clips together
until they lock in place on either side of the connector.
For the serial connector, use a screwdriver to fasten the
screws of the connector, if required.
Insert the interface cable into the U-shaped part of one cable
clip. Lift the left side of the printer up slightly. Then hook
the short lip of the clip into the forward slot and push the
bottom of the clip under the printer until it clicks in place.
Repeat this procedure with the second clip and insert it into
the back slot.
By default, the printer is set up to print letter-size paper from
the standard paper feeder. If you are printing onto any other
size of paper, you need to change the paper tray% paper size
setting. See Chapter 2 in the Reference Guide for more
information.
If you are using the serial interface, see ‘Using the serial
interface” at the end of step 8.