Rotating exhaust cover, Unloading nails – Grizzly H7949 User Manual
Page 12

H7949/H7950/H7951 Nailer
-10
-
Rotating Exhaust
Cover
The exhaust cover rotates as needed to
direct the exhaust away from you.
To rotate the exhaust cover:
1. Use the 4mm hex wrench to loosen the
exhaust cover cap screw as shown in
Figure 10.
Figure 10. Loosening the exhaust cap
screw.
2. Rotate the exhaust cover by hand to
aim the exhaust port in the desired
direction.
3. Tighten the exhaust cover cap screw.
Unloading Nails
To remove unused nails:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Point the nailer away from you and all
bystanders.
3. Open the magazine cover (as shown
on
Page 8) and lift the nails from maga-
zine.
4. Close the magazine cover to keep
the magazine assembly clean until the
nailer is reloaded.
Exhaust
Cap Screw
See also other documents in the category Grizzly Tools:
- H7670 (20 pages)
- H7792 (20 pages)
- H7947 (24 pages)
- G7958 (16 pages)
- G1007 (52 pages)
- G9861 (56 pages)
- G9861 (56 pages)
- Extreme Series Jointer G9860 (76 pages)
- H6331 (20 pages)
- G4179 (32 pages)
- G0500 (71 pages)
- T10446 (16 pages)
- G0463 (40 pages)
- H6143 (20 pages)
- G8125 (2 pages)
- H0800 (6 pages)
- POWER FEED H8370 (4 pages)
- H8116 (20 pages)
- G4003 (55 pages)
- G7948 (2 pages)
- T10010 (28 pages)
- H7668 (24 pages)
- Extren Series Jointer g9860 (76 pages)
- Panther 5 Shelf Unit T10001 (2 pages)
- 28 clipped head framing nailer h6145 (20 pages)
- G1021Z (39 pages)
- Extreme Duty Planners G9740 (76 pages)
- G4008 (26 pages)
- H8154 (1 page)
- 3/8" Impact Wrench w/ Front Exhaust H8119 (2 pages)
- Model H8222 (16 pages)
- G9953ZXF (76 pages)
- COMBINATION SANDER G1183 (48 pages)
- H7758/H7759 (28 pages)
- Extreme-Duty s G9740 (76 pages)
- G2790 (23 pages)
- G0633/G0634 (72 pages)
- G1006 (23 pages)
- Flex Shaft G9928 (12 pages)
- G0456 (48 pages)
- H8170/H8171 (32 pages)
- H7943/H7944 (24 pages)
- H0777 (10 pages)
- 5 GALLON AUTOMATIC MIXING PAINT TANK H8226 (16 pages)