Greenlee 28809-G01 - Manual (Page 39)

OPERATION AND SERVICE INFORMATION
Page 23 Owner’s Manual and Service Guide
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
1/4" below top of reservoir. Add DOT 3 or 4 fluid as
required.
AIR INTAKE AND COOLING FINS
T o p r e v e n t p o s s i b l e
b u r n s , e n g i n e p a r t s
should be kept clean to
reduce risk of overheating and ignition of accumulat-
ed debris.
After every off road use, allow to cool and then check for
a build up of dirt and debris in the air intake and cooling
fins. Dirt and debris may clog the engine’s air cooling
system. Clean areas shown to prevent engine damage
(Ref. Fig. 33 on page 23) (Ref. Fig. 34 on page 23). Keep
linkages, springs and controls clean. Keep area around
muffler free of any combustible material.
REAR AXLE
The rear axle is provided with a lubricant level check plug
located on the driver side at the rear of the housing (Ref.
Fig. 35 on page 23). Unless leakage of rear axle lubricant
is evident, an annual lubricant check is sufficient.
Checking the Lubricant Level
Tool List Qty. Required
Socket, 13 mm, 3/8" drive ........................................... 1
Ratchet, 3/8" drive ....................................................... 1
Funnel ......................................................................... 1
Clean the area around the check and fill plugs. Remove
the check plug. The correct lubricant level is just below
the bottom of the threaded hole (Ref. Fig. 39 on page
26). If lubricant is to be added, remove the fill plug and
add lubricant using a funnel. Add lubricant slowly until
lubricant starts to seep from the check plug hole. Install
the check plug and the fill plug. In the event that the lubri-
cant is to be replaced, a drain plug is provided at the bot-
tom of the differential housing.
AIR CLEANER INSPECTION AND REPLACE-
MENT
Canister Type Air Cleaner
The air cleaner element is accessible by unsnapping the
clips on the air canister and removing the cover and air
filter element (Ref. Fig. 36 on page 24). Clean inside of
cover, canister and dust collector. Install the element and
cover the same way they were removed. Be sure the
positioning arrow on cover is pointing upward and all
clips are fastened securely.
Cleaning the Air Filter Element
Do not use compressed air to clean the
air filter; doing so will damage the filter
which may result in damage to the engine.
If the element is in acceptable condition, loose dirt may
be removed by tapping the filter lightly. Do not use oil on
the filter element or any part of the unit. Install the ele-
Fig. 33 Cleaning Air Intake
Fig. 34 Cleaning the Cooling Fins
! !
Ref Cai 1
Ref Ccf 1
Fig. 35 Add, Check and Drain Rear Axle Lubricant
Check Plug
Drain Plug Ref Raf 2
Fill Plug