Operation and service information, Owner’s manual and service guide – Greenlee 28809-G01 User Manual

Page 35

OPERATION AND SERVICE INFORMATION

Page 19

Owner’s Manual and Service Guide

Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings

The oil should be changed with the engine warm. Park the vehi-

cle on a level surface, engage the park brake and remove the

key. Place a drain pan under the engine. Wipe the top of the

engine clean with a cloth (Ref. Fig. 23 on page 19). Remove the

oil fill cap.

Clean the area around the filter. Oil drainage is accom-

plished by removing the three bolts securing the oil filter

to the engine. Remove the filter by pulling it from the

engine and allow the oil to drain. The ‘O’ rings may

remain on the engine or the filter (Ref. Fig. 24 on page

19).

At each oil change, thoroughly inspect filter before clean-

ing. At the first oil change, metal chips and lint may be

found. This is normal, resulting from engine run-in. At

subsequent oil changes, the presence of metal chips

may indicate possible engine damage.

Wear eye protection to reduce the possi-
bility of splashed solvent contacting the
eyes when cleaning oil filter.

Clean the filter by washing in any shop degreaser and
brushing the metal screen clean with a soft brush (Ref.
Fig. 25 on page 19).

Blow out the filter with low pressure air 30 psi (210 kPa)
or less from no closer than 3" (8 cm) and allow to air dry
(Ref. Fig. 26 on page 19).

Wipe the area around the filter mount with a clean, lint
free cloth and inspect both filter ‘O’ rings for damage;
replace if necessary. Install the filter into the engine. The
filter engages over a short nipple in the engine. The filter
should slide easily onto the nipple and seat against the
engine using light hand pressure only. Align the holes in

Fig. 22 Oil Viscosity Chart

Fig. 23 Clean Top of Engine

-20

100

-30

-20

-10

10W-30

10W-40

HEAVY DUTY WORK

LIGHT DUTY WORK

(AIR TEMPERATURE)

10W-30

Ref Ovc 1

Oil Fill Cap

Ref Cte 1

Fig. 24 Remove Oil Filter

Fig. 25 Clean Oil Filter

Fig. 26 Blowing Out Oil Filter

Oil

Filter

Small 'O' Ring Inside

End Of Oil Filter

Large

'O' Ring

Ref Rof 1

Ref Cof 1

3" (8 cm)
Minimum

30 psi (210 kPa) Maximum

Ref Bof 1