Grizzly G0514X - Manual (Page 28)

-26-
G0514X/-X2/-X2B/-X3 (Mfg. Since 2/12)
figure 34. dust hose attached to bottom dust
port.
Dust collection
To connect a dust collection hose:
1. Fit the 4" dust hose over each dust port and
secure them in place with a hose clamp (see
figure 34).
2. tug the hoses to make sure they do not
come off. Note: A tight fit is necessary for
proper performance.
Recommended cfM at Dust port: 400 cfM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To install the fence:
1. attach the back square tube to the table with
the (2) M6-1 x 16 cap screws as shown in
figure 35.
2. attach the front rail with the (2) M6-1 x 20 hex
bolts, 6mm lock washers, and 6mm flat wash-
ers, as shown in
figure 35.
Installing fence
(G0514X, -X2, X3)
3. install an M8-1.25 hex nut on the fence
handle, then thread the handle into the fence
assembly, as shown in
figure 36. tighten
the hex nut against the fence pivot block to
secure the handle.
figure 35. rail installation.
rear view
Front view
figure 36. handle installed on fence assembly.
pivot Block
hex
nut
DO NOT operate this bandsaw without an
adequate dust collection system. This saw
creates substantial amounts of wood dust
while operating. failure to use a dust col-
lection system can result in short and long-
term respiratory illness.