Glow-worm EnergySaver 40 - Manual (Page 35)

35 221834B
Diagram 14.4
CONTROL THERMOSTAT
SECURING SCREW (2)
OVERHEAT
CUT OFF
LOCKNUT
RETAINING
PIN
OVERHEAT CUT
OFF PHIAL
CONTROL
THERMOSTAT
PHIAL
4078
14 Replacement of Parts
Diagram 14.4A Diagram 14.5
SECURING
SCREW (2)
4067 S
CONTROLS
FASCIA
SECURING
SCREW (3)
HIGH/LOW
CONTROL
KNOB
CONTROLS
FASCIA
CONTROL
THERMOSTAT
KNOB
RESET
BUTTON
FLUE HOOD
OVERHEAT
THERMOSTAT
4066
ELECTRICAL
CONNECTION (5)
ELECTRICAL
CONNECTIONS
14.5 “High/Low” Control: diagram 14.4 and
14.6
Remove the fascia as described in Section 14.4.
Remove the four screws securing the lights bracket.
Remove the locknut to release the “High/Low” control.
Disconnect the three in-line electrical connectors.
When refitting refer to wiring diagram 13.2
14.6 Air Pressure Switch: diagram 14.7.
Remove the air pressure tubes and electrical connections.
Remove the two securing screws to release the air pressure
switch.
When fitting the replacement make sure that all the air pressure
tubes and electrical connections are made as shown.