Grizzly G0705 - Manual (Page 35)

Model G0705 (Mfg. since 09/09)
-33-
4. refer to page 32 for detailed instructions
for installing or removing the drill chuck and
arbor in the spindle.
your machine includes an r-8 drill chuck arbor
and Mt#3 drill chuck. Before use, the drill chuck
must be installed onto the arbor. this drill chuck
installation is intended to be semi-permanent.
tip: For a permanent installation, chill the arbor
in the freezer for 15 minutes before performing the
following procedure. The taper will expand as it
returns to room temperature, permanently locking
the chuck.
to install the drill chuck onto the arbor:
1. Clean the grease off the drill chuck and all
taper mating surfaces. pay particular atten-
tion to the Mt#3 bore in the drill chuck—it
must be free from all grease, oil, and debris.
2. retract the drill chuck jaws fully by turning the
body of the drill chuck counterclockwise.
3. insert the arbor into the drill chuck. tap the
arbor lightly with a brass or other soft-headed
hammer, as shown in
figure 38 to get a
good fit.
note: While it may not seem like there is
anything keeping the drill chuck in place, the
MT#3 taper fit provides a strong bond and will
hold the drill chuck tightly.
the Model g0705 includes two adapters that will
allow the use of Mt#3 and Mt#2 tooling. a drift
key is also included to aid in the separation of the
adapters and any installed tooling.
use the adapters as necessary to fit the tooling
you wish to install. if you are using a tool with an
Mt#2 taper, you will need to use both adapters.
if the adapters become stuck together or tooling
becomes stuck in one of the adapters, use the
drift key to separate them.
to use the drift key:
1. disConneCt MaChine FroM poWer!
2. insert the pointed end of the drift key into the
adapter slot so that it is against the top end of
the lodged adapter or tooling.
3. support the lodged adapter or tooling with a
gloved hand to prevent it from falling out dur-
ing the next step.
4. gently tap on the broad end of the drift key.
the drift key's wedge shape will force out the
lodged adapter or tooling. figure 38. drill chuck.
Brass tip
arbor
drill chuck arbor collet adapters
figure 39. Adapters and drift key.
r-8–Mt#3
adapter
Mt#3–Mt#2
adapter
drift Key