Grizzly 18" x 47" Wood Lathe G0733 - Manual (Page 38)

-36-
Model G0733 (Mfg. Since 10/11)
SEcTiON 6: MAiNTENANcE
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Ongoing:
•
loose faceplate or mounting bolts.
• damaged center or tooling.
• Worn or damaged wires.
• loose machine components.
• any other unsafe condition.
Daily:
•
Clean off dust buildup.
• Clean and lubricate lathe bed, spindle, and
quill.
Monthly:
•
Belt tension, damage, or wear.
• Clean out dust buildup from inside belt/pulley
cavity.
Schedule
Cleaning the model g0733 is relatively easy.
vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth. if any
resin has built up, use a resin dissolving cleaner
to remove it. treat all unpainted cast iron and
steel with a non-staining lubricant after cleaning.
remove and debris or oily substances from the
inside of the spindle and quill.
cleaning
protect the unpainted cast iron lathe bed by using
a lightly oiled rag and wiping it clean after every
use—this ensures moisture from wood dust does
not remain on the bare metal surfaces.
Keep your lathe bed rust-free with regular applica-
tions of products like g96 gun treatment, slipit,
or Boeshield t-9.
Lathe bed
Lubrication
Always disconnect power
to the machine before
performing maintenance.
failure to do this may
result in serious person-
al injury.
all bearings for the model g0733 are lubricated
and sealed at the factory, and do not need addi-
tional lubrication.
Wipe a lightly oiled shop rag on the outside of the
headstock spindle. do Not allow any oil to get on
the inside mating surfaces of the spindle.
use the tailstock handwheel to extend the quill
out to the furthest position and apply a thin coat
of white grease to the outside of the quill. do Not
allow any oil or grease to get on the inside mating
surfaces of the quill.