Grizzly Jointer w/ Spiral Cutterhead G0656X - Manual (Page 13)

COPYRIGHT © FEBRUARY, 2008 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#BL10444 PRINTED IN CHINA
Clean Up
(See Page 13)
The following sliding surfaces must be cleaned:
•
Fence carriage
• Fence bracket
Assembly
(See Page 14)
Assembly of the fence bracket, fence carriage
assembly, and handwheels has changed.
Steps
2-5 below replace Steps 15-17 on Page 15 of the
G0656 Owner's Manual.
1. Follow Steps 1-14 on Pages 14 & 15.
2. Align the mounting holes on the fence bracket
and jointer, and fasten with the M8-1.25 x 35
cap screws, flat washers and lock washers,
as shown in
Figure 2. Do not fully tighten the
fasteners yet.
This update covers changes made to the machine after the owner's manual was printed. All page num-
ber references refer to the owner's manual for this machine. Keep this update with your owner's man-
ual for future reference. If you have questions, contact Tech Support at (570) 546-9663 or by email at
[email protected].
MODEL G0656
8" JOINTER w/BUILT-IN
MOBILE BASE
MANUAL UPDATE
The items below have been added to the original
list of included assembly fasteners:
Assembly Fasteners Qty
• Cap Screws M8-1.25 x 35 (Fence) ............ 4
• Lock Washers 8mm (Fence) ...................... 4
• Flat Washers 8mm (Fence) ........................ 4
• Key 4 x 4 x 12 (Right Handwheel) ............. 1
Machine Inventory
(See Page 11)
The fence assembly and fence bracket are no
longer pre-installed on the jointer assembly by
the factory for shipping, as shown in
Figure 3 on
G0656 Manual Page 11. These items have been
added to the machine inventory ( Figure 1). Refer
to the owner's manual for the rest of the inven-
tory.
Wood Crate (Figure 1): Qty
A. Fence Bracket ........................................... 1
B. Fence Assembly ........................................ 1
B
A
Figure 1. New inventory items.
Fence
Bracket
Figure 2. Fence bracket installed.