Grizzly Jointer w/ Spiral Cutterhead G0656X User Manual

Manual insert

Warning: no portion of this manual may be reproduced in any shape

or form Without the Written approval of grizzly industrial, inc.

#Bl11411 printED in China

the Model g0656X is the same machine as the Model g0656, except it has a spiral cutterhead. Besides
the differences noted in this insert, all other content in the Model g0656 owner's manual applies to this
machine. Before operating your new machine, you Must read and understand this insert and the entire
Model g0656 manual to reduce the risk of injury when using this machine.

If you have any further questions about this manual insert or the differences between the Model G0656X
and the Model G0656, contact our Technical Support at (570) 546-9663 or email techsupport@grizzly.
com.

model g0656X

8" Jointer

w/spiral cutterhead

manual insert

machine inventory

refer to the inventory photos in the g0656

Manual on

page 11. after all the parts have been

removed from the crate, you should have the fol-
lowing items:

Wood crate:

Qty

a. Jointer assembly ........................................ 1

b. Cutterhead guard ....................................... 1

c. handwheels ................................................ 2

d. handles ...................................................... 2

e. Fence tilt lever ......................................... 1

f. push Blocks ................................................ 2

g. spiral Cutterhead hardware (not shown)

— inserts 14 x 14 x 2 .................................. 5
— Flat head torx screws t20 M6-1 x 15 10
—l-Wrench torx t20 ................................. 1
—Driver Bit torx t20 ................................. 1

h. tool hardware Bag

— hex Wrenches 2.5, 3, 4, 6mm ..........1 Ea
—open-End Wrench 8/10, 12/14mm .....1Ea

the Model g0656X Cardboard Box and assembly
Fastener Components are identical to the cor-
responding components listed on

page 11 of the

g0656 Manual.

setting outfeed table height

the outfeed table height Must be level with the
carbide inserts when they are at top-dead-center.
if the outfeed table is set too low, the workpiece will
be tapered from front to back. if the outfeed table
is set too high, the workpiece will hit the edge of
the outfeed table during operation, increasing the
chance of kickback.

to set the outfeed table height:

1. DisConnECt JointEr FroM poWEr!

2. Move the cutterhead guard out of the way or

remove it, and open the rear access panel.

figure

. Cutterhead insert at top-dead-center.

Ide9ZVY

8ZciZg

7diidb9ZVY

8ZciZg

3. place a straightedge on the outfeed table

so it extends over the cutterhead and rotate
the cutterhead pulley until one of the carbide
inserts is at top-dead-center (tDC), as shown
in

figure 1.