GE Monogram ZGU375NS - Manual (Page 8)

Installation
Stainless Steel G a s Cooktop
8
• Check to be sure the receptacle is properly
wired by checking for proper polarity and
grounding.
• Plug in power cord.
• Remove tape on burners.
• Assemble burner as shown. Check to be sure
that burner heads and caps are securely
seated. Pin(s) must completely engage holes
to ensure proper assembly.
3
Connect
electrical
Step
4
Assemble
burners,
check ignition
Step • Check for proper ignition:
– Push in one control knob and turn 90
° to
HIGH position.
– The igniter will spark and the burner will
light; the igniter will cease sparking when
the burner is lit.
– First test may require some time, while air is
flushed out of the gas line.
– Turn knob to OFF.
– Repeat the procedure for each burner.
IMPORTANT: If the ignitor electrodes
continue to spark after the burners are lit,
check that each burner component is
assembled and seated properly by observing
constant gaps between each layer. Disassemble
and reassemble as required.
To aid reassembly, each
brass Burner Head is
marked with a clock face.
Replace the Burner Head
with the arrow pointing
to the rear of the cooktop
(12 o’clock position).