Grizzly G1019Z - Manual (Page 22)

-20- Model G1019Z 14" Bandsaw
Table Adjustments
The bandsaw table will tilt left 10° and right 45°
from horizontal. When tilting the table to the right,
the positive stop adjusting bolt automatically
indexes the table perpendicular to the blade.
To tilt the table to the right:
1. Loosen the two trunnion knobs below the
table trunnions.
See Figure 18 for location.
2. Position the table to the desired angle.
Refer to the angle gauge on the front table
support trunnion.
3. Tighten the trunnion knobs.
Figure 18. Table tilt trunnion knobs.
Figure 19. Table tilted left.
To tilt the table to the left:
1. Loosen the two trunnion knobs below the
table trunnions.
2. Tilt the table to the right enough to gain
clearance to the positive stop bolt. Loosen
the lock nut, then remove the positive stop
bolt.
3. The table will now tilt left to approximately
10°.
See Figure 19.
4. When the left tilt operation is complete, rein-
stall the positive stop bolt.
Trunnion Knobs
To adjust the positive stop so the table will be per-
pendicular (90°) to the blade:
1. Loosen two trunnion knobs and the locknut
securing the positive stop adjusting bolt.
2. Raise the upper blade guide assembly and
place a 6" adjustable square or try-square
on the table against the blade.
See Figure
20. Adjust the positive stop adjusting bolt so
that the table is positioned at a 90° angle to
the blade.
3. Secure the trunnion knobs and lock the pos-
itive adjusting bolt by tightening the locknut.
Ensure that the bolt does not turn while
tightening the locknut. Set the angle pointer
to zero for future reference.
Figure 20. Squaring table to blade.