GE Profile Wine Chiller - Manual (Page 4)

Installing the wine chiller.
4
Removing the Packaging
Before using the wine chiller, be sure all packing materials and tape have been removed,
including the protective film covering the control and any film protecting the cabinet.
If you are discarding an old refrigeration product, remove the doors to reduce the danger
of children being trapped inside.
To raise the wine chiller
■
The wine chiller can be freestanding
or can be installed under the counter,
with proper clearances.
■
Allow the following clearances for ease
of installation, proper air circulation
and electrical connections:
Each side 1 1 ⁄
2
″ (38 mm)
Top 2
″ (51 mm)
Back 2
″ (51 mm)
■
Do not install the wine chiller where
the temperature will go below 55°F
(13°C) or above 90°F (32°C).
■
Install it on a level floor.
■
Do not install the wine chiller where it
will be subject to direct sunlight, heat
or moisture.
■
Do not store or install this appliance
outdoors.
Installation Guidelines
Adjustable legs at the front corners of
the wine chiller should be set so the
wine chiller is firmly positioned on the
floor, with a 1/8
″ tilt to the back to help
the door closure.
To adjust the leveling legs, turn the legs
clockwise to raise the wine chiller,
counterclockwise to lower it.
Leveling Legs
Consumer Support
Tr
oubleshooting T
ips
Operating
Instructions
Safety Instructions
Installation Instructions
Care and Cleaning