GarrettCom DS50 - Manual (Page 11)

Magnum DS50 / DS60s Dual Speed Hubs Installation and User Guide (06/02)
DS60s are “plug and play” units enclosed in a lightweight, compact, rugged metal enclosure
suitable for office, lab and industrial sites. The DS50 / DS60s are available for horizontal or
vertical mounting (see Section 3.1).
2.2.1
Magnum DS60F Dual-speed Hubs Plus, with Fiber Switched Port
The Magnum DS60F chassis houses one main board equipped with five
hub ports and a switched fiber port. The switched fiber port is available with an SC connector
and options of multi-mode,
single-mode and long reach. It
has an internal power supply and
a small cooling fan in the bottom,
extending ambient operation to
55C. The port side of the chassis
consists of five shared 10/100Mb
RJ-45 ports and one 100Mb
switched SC fiber port. There is
an up-link (UPLINK) switch next
to Port 1, which allows this port
to be used for cascading to a hub
or switch. There is a manual switch “F-H” underneath the switched port #6 which provides
“Full-duplex” and “Half-duplex” capability to the switched port
The Magnum DS60F has power (PWR) and collision (COL) LED’s and 10 and
100 LEDs for the unit. It also has link (LINK) and receive (RX) activity LEDs for each of the
five shared ports and for Port 6. The port #6 has a Full-duplex (FDX) and a speed (100) LED
also. Rubber feet on the bottom provide a sturdy grip and clearance for the exhaust of the
cooling fan.
The internal power supply is an auto ranging AC power supply for input of 115-230
vac, 50/60 Hz. Optionally available are 24VDC and -48VDC for the industrial and telecom
markets. The recessed male IEC power connector is located at the right-rear. Two mounting
brackets for optional wall mounting are supplied with each unit. An optional “edge- stand” is
available (See “Spare Parts Price List”) and is used for floor-mounting on carpeted surfaces.
7
www GarrettCom com . .