Grizzly 1 1/4" Brad Nailer T20568 - Manual (Page 14)

t20568 1 1 ⁄
4
" brad nailer -12 -
cleaning & lubrication
lubricating
pneumatic tool oil has been included with
your new grizzly nailer to help maintain
its useful life. place two to six drops of oil
in the nailer air inlet (as shown in
figure
8) before every use, or after 2 hours of
continuous use.
Wipe off any excess oil near the nailer
exhaust to avoid dust build-up. When the
oil that was included with the nailer has
been completely used, replace with grizzly
model g2820 pneumatic tool oil.
another option to manual oiling would be
to install a lubricator in your air compressor
line. if your air compressor line already has
a lubricator, then regular lubrication of your
nailer will not be necessary. Just make
sure there is always oil in the lubricator.
figure 8. lubricating nailer via air inlet.
cleaning
use a good solvent to clean the nose
assembly of the nailer. always be sure that
the nailer is dry before using it again.
do not allow dust, chips, sand, etc. into
the air connectors or into the body of the
nailer; this may result in leaks and damage
to the nailer and the air couplings.
never use gasoline or other flamma-
ble liquids to clean this tool. vapors
in the tool may ignite, causing the
tool to explode. ignoring this warning
may lead to serious personal injury or
even death!