Stovax 7126 - Manual (Page 9)

9
PR8019
7.2 Multi-fuel:
De-ash the appliance before filling with new fuel. Do not
allow ash to build up on the underside of the grate as this
can cause premature failure.
• Riddle, See Diagram 11
Riddling
Handle
• Open Doors, See Diagram 9
7.3 Remove Ashpan carefully. Heat can remain long after use,
See Diagram 12
7.4 Use gloves, or place the ash into a Stovax Ash Caddy
(Stovax Part No. 4227)
7.5 Do not place hot ash in a bin made from plastic or any
other combustible material.
8. OVER NIGHT BURNING
8.1 It is possible to get the appliance to burn over night.
In order to do this:
• De-ash prior to final refuelling
• Set air controls to low combustion settings
USER INSTRUCTIONS
This will blacken the glass over night but it will clear when
operated at high output for a short period.
• Use smokeless fuel or small, thick logs depending on fuel
desired
9. OVER-FIRING
9.1 Do not over-fill with fuel or use at maximum output for
long periods or over-firing can occur. If the flue pipe, flue
collar or top plate glow red the appliance is over-firing:
• Close the air controls to reduce the output
9.2 Over-firing can cause permanent damage to the appliance.
10. CHIMNEY FIRE
10.1 If a chimney fire occurs:
• Shut all air controls immediately
• Evacuate the building
• Call the fire brigade
• Do not re-enter the building until it is confirmed safe
10.2 Do not use the appliance after a chimney fire until:
a) It has been inspected by a registered installer,
confirming the appliance is safe to use*
b) The chimney system inspected and swept by a chimney
sweep, confirming the system is structurally sound and free
from obstruction before re-use.**
c) It is repaired as required before re-use. Use only
genuine Stovax replacement parts to keep your appliance in
safe and efficient working order.
11. GENERAL CLEANING
11.1 Allow appliance to cool thoroughly to avoid risk of burns:
• Clean regularly, according to the level of use
• Give attention to the baffle system, flue ways and
removing ash
Regular cleaning and maintenance will help give many years
of safe use.
• Clean matt black appliances using Stovax Collodial black
or Stovax Grate Polish
To refresh painted finishes use Stovax Thermolac paint.
• Clean enamel finishes using warm soapy water and a soft
clean cloth
• Do not use aerosol sprays near an operating appliance
Wipe dry with a soft clean cloth before re-lighting. Do not
leave unit without drying, as this may cause rust.
Do not use abrasive cleaner or cleaning pads to clean
enamel finishes .
In the U.K:
* registered with HETAS (GB only)/INFO (Republic of
Ireland only)
** This should be done by a NACS registered (UK only)/
INFO registered (Eire only) chimney sweep, who will issue
you with a certificate.