Stovax 7126 - Manual (Page 25)

25
• Lay the door face down on a soft flat surface, to protect
the paintwork and glass
• Remove the old rope and scrape old glue from the
locating groove
Clean the locating groove with a clean dry cloth to remove
all old dust and debris.
• Squeeze a generous bead of fresh Stovax Thermic Seal
glue into the rope locating groove
• Press the new Stovax rope into the locating groove,
placing the joint in the middle of the lower edge of the
door
• Refit the door and close the door to apply pressure to the
new rope
• Leave the appliance closed for at least 12 hours before
lighting the appliance and using at a low output for
approximately one day
7.2 Using the appliance with a damaged door seal can cause
dangerous fumes to enter the room, or the appliance to
over fire, resulting in damage.
8. ADJUSTING DOOR HINGES
8.1 To maintain the safe use of your Stockton, you may need to
adjust the door hinges to ensure the safe, correct closing of
the door. Complete this operation as follows.
8.2 Open the door to give access to the hinge block fixing nut.
Fixing Nut Lock Nut
1
8.3 Using a 20mm A/F spanner loosen the fixing nut inside
the stove as shown in diagram 1, and reposition the hinge
blocks to achieve a correct fit. This may need a trial and
error approach to find the correct position.
MAINTENANCE and SERVICING