Grizzly H7762 - Manual (Page 15)

H7762 Heavy Duty Tool Grinder -13-
Mounting
The Model H7762 weighs 92.5 lbs. Make sure
the workbench on which you plan to mount the
grinder is sturdy enough to hold the weight of the
machine and any downward pressure that may be
applied during operation. The workbench should
have a level surface and be heavy, or attached to
the floor so that it will not move or vibrate during
operation.
Components and Hardware Required Qty
Grinder Unit ....................................................... 1
Hex Bolt M8-1.25 (length varies) ....................... 4
Flat Washer 8mm .............................................. 8
Lock Washer 8mm ............................................ 4
Hex Nut M8-1.25 ............................................... 4
Note: Because sizes vary for each individual situ-
ation, the hardware in this step is not included
with the Model H7762.
Figure 4. Mounting machine to the workbench.
H7762
Base
Workbench
Flat
Washer
Lock
Washer
Bolt
Hex Nut
Mount the grinder as shown below: