GE 21018 - Manual (Page 34)

34
NOTE: If the battery is not properly installed in the handset, or if the battery pack
is not properly connected to the jack inside the battery compartment. "NO
BATTERY" shows in the display when the handset is placed in the charging cradle.
B
ATTERY
S
AFETY
P
RECAUTIONS
• Do not burn, disassemble, mutilate or puncture. Like other batteries of
this type, toxic materials could be released which can cause injury.
• Keep batteries out of the reach of children.
• Remove batteries if storing over 30 days.
B
ELT CLIP AND
O
PTIONAL
H
EADSET
C
ONNECTING THE
B
ELT
C
LIP
1. To attach the belt clip, insert the sides of the belt
clip into the slots on each side of the handset.
2. Snap the ends of the belt clip into place.
C
ONNECTING AN
O
PTIONAL
H
EADSET TO
THE
H
ANDSET
Each handset can be used with an optional
headset hands free operation.
1. Connect the headset to the headset jack
on the side of the handset The handset
receiver and microphone are disabled
when the headset is connected.
2. Adjust the headset to rest comfortably on
top of your head and over your ear. Move
the microphone to approximately two to
three inches from your mouth.
Headset jack
Headset Plug
Belt clip
Slot for
belt clip Slot for
belt clip
NOTE: The RBRC seal on the battery used in your ATLINKS
USA, Inc. product indicates that we are participating in a
program to collect and recycle Nickel Cadmium batteries
throughout the United States. Please call 1-800-8-BATTERY for
information or contact your local recycling center.