GE 21018 User Manual

Page 12

NSTALLING

THE

ANDSET

ATTERY

NOTE:

You must connect the handset battery before use.

1. Push down on the top of the battery compartment cover (located on the

back of each handset) and remove the cover.

2. Lift the battery pack and connect it's plug to the jack inside the compartment.

NOTE:

It is important to maintain the polarity (black and red wires) to the

jack inside the compartment as shown in the illustration.

3. Close the battery compartment by pushing the cover up until it snaps

into place.

4. Place the handsets in the charging cradles.

Allow handsets to charge for 16 hours prior to first use. If you don’t
properly charge the handsets, battery performance is compromised.

NOTE:

If the battery is not properly installed in the handset, or if the battery

pack is not properly connected to the jack inside the battery compartment.
"NO BATTERY" shows in the display when the handset is placed in the
charging cradle.

BLACK WIRE

RED WIRE

BATTERY

PRESS DOWN
FIRMLY