Grizzly 2-in-1 COMBINATION NAILER/STAPLER H7664 - Manual (Page 17)

h7664 2-in-1 Combination nailer/stapler -17 -
section 5: maintenance
cleaning
disconnect the nailer/stapler from the
air supply before cleaning. Use a good
solvent to clean the nose assembly of
the nailer/stapler. always be sure that the
nailer/stapler is dry before using it again.
do not allow dust, chips, sand, etc. into
the air connectors or into the body of the
nailer/stapler; this may result in leaks and
damage to the nailer/stapler and the air
couplings.
lubricating
figure 8. Lubricating nailer/stapler via air
inlet.
never use gasoline or other flamma-
ble liquids to clean this tool. vapors
in the tool may ignite, causing the
tool to explode. ignoring this warning
may lead to serious personal injury or
even death!
place two to six drops of pneumatic tool
oil in the nailer air inlet (as shown in
figure 8) every 2 hours of continuous
use. Wipe off any excess oil near the nailer
exhaust to avoid dust build-up. Model
g2820 pneumatic tool oil is available
from grizzly.
another option to manual oiling would be
to simply install a lubricator in your air
compressor line. if your air compressor
line already has a lubricator, then regular
lubrication of your nailer will not be neces-
sary. Just make sure there is always oil in
the lubricator.