Grizzly 2-in-1 COMBINATION NAILER/STAPLER H7664 - Manual (Page 14)

h7664 2-in-1 Combination nailer/stapler -14 -
a jammed nail or staple must be cleared
before using the nailer/stapler again.
to clear a jammed nail or staple from
the magazine:
1. disconnect the nailer/
stapler from the air
supply!
2. Unlock the catch lever and pull the
magazine pusher back completely.
3. Locate and remove the jammed nail/
staple with a pair of needle nose pli-
ers.
4. throw the damaged nail/staple away.
5. inspect the nail/staple stick. if it is bent
or damaged, throw it away and insert
a new stick that only contains clean,
undamaged nails/staples. do not
use dirty or damaged nails/staples!
6. push the magazine pusher forward
to the front of the magazine until the
catch lever locks.
clearing Jammed
nails/staples
single/bump fire
operation
the nailer/stapler is designed to fire one
nail/staple at a time, or one after another,
using the safety yoke mechanism. this is
known as "bump fire".
to operate your nailer/stapler in single
fire mode:
1. depress the safety yoke mechanism
against the workpiece.
2. pull the trigger, then remove your finger
from the trigger after the nail/staple is
driven.
to operate your nailer/stapler in bump
fire mode:
1. pull the trigger.
2. press the safety yoke mechanism
against your workpiece and raise it
after the nail/staple is driven.
3. hold the trigger and repeat step 2 to
drive more nails/staples.