Gateway FHD2402 - Manual (Page 22)

CHAPTER 1: Using Your Gateway Flat-Panel Monitor
18
What happens if I lose signal to the display while watching a movie on a HDCP-equipped
component?
The component must be restarted to establish renegotiation.
For example, while watching a movie on a HDCP-enabled DVD player, you change the receiving
device (DTV, monitor, or projector) input to watch broadcast TV, then change the input back to watch
the DVD movie. However, you are unable to watch the movie. This is because when the input was
changed, the receiver lost the HDCP signal. Restart the HDCP-enabled DVD player to allow
renegotiation.
What is the cause if a movie starts and then slowly fades to static?
The receiving device is not HDCP compatible or it is not negotiating correctly. Restart the video
source and re-plug all video cables from the source to the TV.
How do I know if a component is HDCP compliant?
If the video source device does not have a DVI or HDMI connection, it is not HDCP compliant.
Video/Display
I see black bars on left and right of the video. Can I stretch the video to fit more of the screen?
Press the Menu button on the right hand side of the display, select Main Menu, then select Video
Adjust, then select Video Scaling. To fill more of the screen, choose Full mode.
Important
Although the HDMI interface supports audio, no audio is sent to the monitor. You must
separately connect the audio output of your video device to an external audio amplifier.