Gateway Unmanaged Ethernet Switch - Manual (Page 18)

15
Installing the 16- and 24-port switches
www.gateway.com
3
With the assistance of another person, hold the switch in place in the rack
and secure with two screws and nuts on each side (provided.
4
Install the cables and power cord.
Power on
Plug one end of the AC power cord into the power connector of the switch
and the other end into the local power source outlet.
After the switch is turned on, the LED indicators will momentarily blink. This
blinking of the LED indicators represents a reset of the system.
Power failure
If a power failure occurs, unplug the switch. When power is resumed, plug the
switch back in.