Glowworm Lighting 250 I - Manual (Page 4)

4
Installation and Use Regulations
In your own interests and that of safety, it is the LAW that this
product is installed by a competent person in accordance
with the current issue of these regulations.
Control of Substances Hazardous to Health
Under Section 6 of The Health and Safety at Work Act
974, we are required to provide information on substances
hazardous to health.
The adhesives and sealants used in this product are cured
and give no known hazard in this state.
Manual Handling
With regards to the “Manual Handling Operations, 99
Regulations”, the appliance exceeds the recommended
weight for a one man lift.
Electrical Supply
The product MUST be earthed.
All system components shall be of an approved type and all
wiring to current I.E.E. wiring regulations.
External wiring must be correctly earthed, polarised and in
accordance with the relevant standards.
In GB, this is BS 767.
In IE, this is the current edition of ETCI rules.
The product MUST be connected to a permanent 30V ac,
50Hz supply.
Connection of the whole electrical system of the product,
including any heating controls, to the electrical supply MUST
be through one common isolator and must be fused 3 Amp
maximum.
Isolation should be by a double pole switched fused spur box,
with a minimum gap of 3mm for both poles. The fused spur
box should be readily accessible and preferably adjacent to
the product. It should be identified as to its use.
Alternatively connection can be made through an unswitched
shuttered socket and 3A fused 3-pin plug both to the current
issue of BS 363, provided they are not used in a room
containing a bath or shower.
Wiring to the product must be PVC 85°C insulated cable, not
less than 0.75mm (4/0.0mm).
Testing and Certification
This product is tested and certificated for safety and
performance. It is, therefore, important that no alteration is
made to the product, without permission, in writing, by Glow-
worm.
Any alteration not approved by Glow-worm, could invalidate
the certification, warranty and may also infringe the current
issue of the statutory requirements.
CE Mark
The CE mark on the Fluropro solar control indicates that
it complies with the basic requirements of the applicable
directives as stated on the data badge.
“Benchmark scheme”
Glow-worm support the Benchmark initiative. It is very
important that the service record is completed by the
installation engineer and handed over to the user.
WARNINGS
SAFETY
The flurocyl must be installed by a competent person, who is responsible for adhering to
the existing standards and regulations.
Important Information
ALTERATIONS
Under no circumstances should you ever attempt to make alterations to these
components or any other part of the system
SEALED COMPONENTS
Under no circumstances must the user interfere with or adjust sealed parts.