Fisher & Paykel Aerotech OD302 - Manual (Page 39)

37
Using the Self Clean mode
1 Remove oven shelves, shelf supports (see ‘Cleaning’) and all other cookware/utensils from the
oven before using the Self Clean mode.
2 Select the Self Clean mode by turning the oven mode dial.
3 Select the maximum temperature using the temperature dial, will appear in the display
and this will change to
when the cycle begins. The
DOOR LOCK
and
CLEAN
symbols
will show in the clock display and the time remaining will count down.
For your safety the door lock will automatically activate once the Self Clean mode and
temperature has been selected.
4 At the end of a self clean cycle, the door will unlock and the DOOR LOCK
symbol will
disappear. The CLEAN
symbol and
will flash in the clock display and in the mode
display until the oven is returned to manual operation - To do this turn the oven mode and
temperature dials to ‘OFF’.
5 At the completion of the self clean cycle, you will notice grey ash deposited inside the oven.
The amount of ash in the oven is dependent on the amount of soil present in the oven before
it was cleaned. When the oven is completely cooled, the ash is easily removed with a small
brush or dry cloth, then wipe out the oven with a clean damp cloth and dry with a clean
lint-free cloth.
6 Replace the shelf supports (see ‘Cleaning’) and oven shelves.
To cancel the Self Clean mode before it has finished
Turn the oven mode and temperature dials to ‘OFF’. will appear in the oven mode
display and the door will remain locked until the oven has cooled to a safe temperature.
Do not turn the power to the appliance off as the fans are necessary to cool the oven.
If the oven is cool or below the safe temperature it will return to normal operation and the
clock display will show the time of day.
Short Self Clean cycle
A shorter self clean cycle can be selected if the oven is only lightly soiled:
1 Select the Self Clean mode by turning the oven mode dial.
2 Select the maximum temperature using the temperature dial.
3 While is shown in the display, press the button. The COOK TIME
and
AUTO
symbols
and the colon will flash.
4 Rotate the Setting Selector dial to reduce the time; this can be anywhere between two
and three hours.
5 Press the button again or wait eight seconds to adopt the setting and start the self clean
cycle. The clock display will show the time remaining.