FieldServer FS-8700-101 - Manual (Page 22)

FS-8700-101_Setra Model 370 Digital Pressure Gage Manual Page 22 of 23
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com
Tel : (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: [email protected]
Appendix C.2. Standard Driver Stats
Driver Statistics Recorded Explanation
PLC Read Messages sent Number of message sent to the Gage
PLC Write Messages sent Should be zero
PLC Bytes sent Total number of bytes sent by the Client side driver
PLC Message received
Total number of messages of all types received (ACK,
NAK, error response, normal response) on the Client side
driver.
PLC Bytes received
Total number of bytes received by all message types on
the Client side driver.
Protocol
Protocol errors are incremented when the Client side
cannot correctly parse a response message from the
Gage. This includes responses that are formatted
differently from what the driver expects, or messages that
report the Gage is ‘unable’ or in setup mode.
IC_Timeout
Incoming message buffer experiences an excessive
delay between incoming bytes
Timeout
Client side messages that were not responded to by a
Server. Possibly a communications error or a command
was made to a unit that does not exist.
Streaming
Message size was too large for the input buffer. This
should never occur.
Exception
Increments when a ‘status’ response contains a line with
insufficient information for storage but which may be a
heading.