beautypg.com

FUJITSU MAP3735FC User Manual

Page 76

background image

Installation

5-14

C141-E163

Notes:

1.

The user can arbitrarily specify the following parameters according to the system
requirements:

ARRE

AWRE

TB

PER

2.

The user also can arbitrarily specify parameters other than the above. However, it is
recommended to use the default setting in normal operations.

(2)

Disconnection/reconnection parameters (page code = 2)

The following parameters are used to optimize the start timing of reconnection processing to transfer
data on the loop at a read (READ or READ EXTENDED command) or write operation (WRITE,
WRITE EXTENDED, or WRITE AND VERIFY command) of the disk. Refer to Chapter 2 of Fibre
Channel Interface Specifications for further details.

Parameter

Default value

• Buffer full ratio

00 (HEX)

• Buffer empty ratio

00 (HEX)

Notes:

1.

In a system without the disconnection function, these parameters need not be specified.

2.

Determine the parameter values in consideration of the following performance factors of the
system:

Time required for reconnection processing

Average amount of processing data specified with a command

Refer to Chapter 2 of Fibre Channel Interface Specifications for how to obtain the rough
calculation values for the parameter values to be set. It is recommended to evaluate the
validity of the specified values by measuring performance in an operation status under the
average system load requirements.

This manual is related to the following products: