FUJITSU MAP3735FC - Manual (Page 101)

C141-E163 GL-1
Glossary
CCS
Common Command Set
This is the standard form of SCSI logical specifications stipulated by the
operations subcommittee of the American National Standards Institute (ANSI)
which stipulates functions which a direct access device (magnetic disk, etc.)
should support.
CDB
Command Descriptor Block
A series of data which describes commands related to input/output operations,
sent from the initiator to the target.
Command
This is a command to a target to perform an input/output operation, and it is
described as the CDB.
FC Device
The general name given to a device which is connected to the FC bus
(input/output device, I/O controller, host adapter, etc.).
Initiator (INIT)
This is a SCSI device which initiates input and output operations on the SCSI bus.
In this manual, initiator has been abbreviated to "INIT."
SCSI
Small Computer System Interface
The standardized input/output interface of the American National Standards
Institute (ANSI). [Standard No.: ANSI X3. 131-1986]
Sense Code
This is a 1-byte code displayed in the sense data and is information which
specifies the type of error that was detected.
Sense Data
When several items of error information are included in a command's completion
status, this is information generated by the target for reporting detailed
information on that status.
Sense Key
This is a 4-bit code displayed in the sense data. It contains information for
classifying the type of error that was detected.
Status
This is 1 byte of information reported to the initiator by the target device when
execution of each command is completed, which displays the command's
completion state.