FUJITSU MAP3735FC - Manual (Page 56)

Installation Requirements
4-4 C141-E163
e) Must be handled on an anti-static mat.
5.0 or less
5.0 or less
Figure 4.3Mounting frame structure
(2) Limitation of side-mounting
Mount the IDD using the 4 screw holes at the both ends on the both sides as shown in Figure 4.4. Do
not use the center hole by itself.
In case of using the center hole, it must be used in combination with 2 holes on both ends.
(Total 6 screws for 6 holes enclosed)
Holes for mounting screw
Center holes
1
2
3
4
Holes for
mounting screw
Use four holes (No.1-4) to mount
Figure 4.4 Limitation of side-mounting