Furuno FM-4000 User Manual

Page 48

FM-4000

Page 48

want to communicate on, then press the [ENT]
key.

6. Press the [ENT] key again to transmit the Group

call signal.

7. When the Group call signal is sent, the LCD

displays the information shown in the illustra-
tion at right.

8. After the Group call is transmitted, all the ra-

dios in the group switch to the designated chan-
nel.

9. Listen to the channel to make sure it is not busy,

then key the microphone and call the other ves-
sels you desire to communicate with.

Manual Calling
You may enter a Group MMSI number manually to contact a group whose
Group call number is not registered in the radio.

1. Press the [CALL(MENU)] key to show the “DSC

DSC

Call Menu

.”

2. Turn the CHANNEL selector knob to select

“Group

Group

.” (To cancel, press the [CLR] key.)

3. Press the [ENT] key. The transceiver beeps

then the “Group Directory” appears.

4. Turn the CHANNEL selector knob to select

“Manual

Manual

,” then press the [ENT] key.

5. Enter the MMSI number (nine digits: first digit per-

manently set to “0”) which you want to contact, then
press the [ENT] key.

6. If you enter a wrong number in the MMSI number,

press the [H/L] key until the wrong number is se-
lected, then enter the correct number.

7. When you have finished entering the MMSI

number, press and hold the [ENT] key.

8. Turn the CHANNEL selector knob to select

“

Manual

,” then press the [ENT] key.

9. Turn the CHANNEL selector knob to select the op-

erating channel you want to communicate on, then
press the [ENT] key.

10. Press the [ENT] key again to transmit the Group

call signal.