Furuno FM-4000 - Manual (Page 32)

FM-4000 Page 32
10.17 INTERCOM OPERATION
Connecting the optional CMP30 Remote MIC to the FM-4000 allows Intercom
communications. See section “13.2 INTERCOM OPERATION” for operation
of the CMP30.
10.17.1 Communication
1. Press and hold the [5(IC)] key while in the “Radio” mode to change to the
“Intercom” mode.
2. If your FM-4000 is equipped two Remote MICs, use the CHANNEL selec-
tor knob select the one of use (RAM1 RAM1 RAM1 RAM1 RAM1 , RAM2 RAM2 RAM2 RAM2 RAM2 , or
ALL ALL ALL ALL ALL ), then press the [ENT] key.
3. When the “Intercom” feature is activated, “Intercom Intercom Intercom Intercom Intercom ”
appears on the FM-4000 and CMP30.
4. Press the PTT switch. “Talk Talk Talk Talk Talk ”
appears on the display.
NOTE: A warning beep is emit-
t e d w h e n t h e F M - 4 0 0 0
microphone’s PTT switch is
pressed while the Remote
MIC’s PTT switch is pressed.
5. Speak slowly and clearly into
the microphone, holding the
microphone about 1/2 inch
away from your mouth.
6. When finished, release the
PTT switch.
7. Press the [CLR] key to return
to the “Radio” mode.
(FM-4000 display) (CMP30 display)
(FM-4000’s PTT switch is pressed)
(CMP30’s PTT switch is pressed)
ALL RAM 1 RAM 2 Ù RADIO RAM 2 Ù RADIO RAM 1 Ù
RAM 1 RAM 2
DISTRESS P ULL OP E N
-/*
JKL
RAM 1 RAM 2
DISTRESS P ULL OP E N
-/*
JKL
RAM 1 RAM 2
DISTRES S P ULL OP EN
-/*
JKL
RAM 1 RAM 2
DISTRES S PULL OPE N
-/*
J KL