Fostex LM16 - Manual (Page 8)

Model LM16 [Introduction/Overview]
8
• For normal cleaning, use a soft dry cloth.
For stubborn dirt, moisten a cloth in
diluted detergent, wring it out firmly, and
wipe the dirt off.
Then polish with a dry cloth. Never use
solvents such as alcohol, thinner or
benzene, since these will damage the
printing and finish of the exterior.
• When temperature and humidity change
suddenly (for example, when you move the
LM16 from a cold place to a warm place),
moisture condensation may occur to the
display and panel.
In such a case, leave it with the power
turned off for some time until the
moisture evaporates.
Cleaning the exterior
Condensation
• Fostex is not responsible for any “direct
damage” or “indirect damage” caused by
using the LM16.
About damage
• Use only a CAT-5 STP cable for connection
between the main unit and the control
unit.
About CAT-5 cable
: Do not connect or disconnect a
CAT-5 cable while the LM16 is powered
on. When you connect or disconnect a
CAT-5 cable, make sure that the LM16 is
powered off.