FIC M296 - Manual (Page 58)

Software Functional Overview
3.3.7 Super I/O
This controller contains 16550A or FIFO Enabled UART, ECP/Standard/Bi-
directional Parallel Port meeting the 1284 specification, and an Infrared port that
supports IrDA Super IR.
3.3.8 PCMCIA
ƒ Individually accessed, dual-buffer implemented.
ƒ Support for 1 CardBus slots (one type II stacked).
ƒ Support for 3.3v, 5v and 12v (flash programming) cards.
3.3.9 LED Indicator
The table below lists down the functions of the Status LED indicator:
Indicator Function Description
IDE accessing LEDn This LED will turn on while accessing the IDE Device.
FDD accessing LEDn This LED will turn on while accessing the FDD Device.
Battery Charging LED Turn on (Amber) – Battery is under charging mode
Turn off – Battery full charged or no battery
CapsLock LEDn This LED will turn on when the function of CapsLock is active.
ScrollLock LEDn This LED will turn on when the function of ScrollLock is active.
NumLock LEDn This LED will turn on when the function of NumLock is active.
Power Status LED Green – System is powered on.
Green Blinking- System is entered suspend mode.
Amber – Battery Low.
Mail LEDn This LED will turn on while Mail was arrived.
GPRS statusn This LED will turn on while GPRS module power on.
L
n - There LEDs will be turned off during Suspend mode.
3.3.10 Hot Keys Definition
All Hot keys must be active at all times under all operation systems.
z
Hot Keys by Internal Keyboard
Hot Key Function Handler
Fn + F3 Toggle Display
(LCD/CRT/TV/LCD&CRT) BIOS Handler
Fn + F6 System Speaker On/Off BIOS Handler
Fn + F8 Brightness Increase Controlled by PMU08
Fn + F9 Brightness Decrease Controlled by PMU08
3-8
FIC M295 / M296 Service Manual