Hardware functional overview – FIC M296 User Manual
Page 114
Hardware Functional Overview
The OZ6912 CardBus controller is compliant with the latest ACPI-PCI Bus Power
Management interface Specification. It supports all four power states and the PME# function
for maximum power savings and ACPI compliance. Additional compliance to On Now Power
Management includes D3 cold state support, paving the way for low sleep state power
consumption and minimized resume times. To allow host software to reduce power
consumption further, the OZ6912 provides a power-down mode in which internal clock
distribution and the PC Card socket clocks are stopped. An advanced CMOS process is also
used to minimize system power consumption.
The OZ6912 single PCMCIA socket supports the 3.3V/5V 8/16-bit PC Card R2 cards or 32-
bit CardBus R3 cards. The R2 card support is compatible with the Intel 82365SL PCIC
controller, and the R3 card support is fully compliant with the 2000 PC Card Standard
CardBus specification. The OZ6912 is an additional buffer chip for the PC Card socket
interface. In addition, the OZ6912 supports dynamic PC Card hot insertion and removal, with
auto configuration capabilities.
The OZ6912 is fully complains with the 33Mhz PCI Bus specification, v2.2. It supports a
master device with internal CardBus direct data transfer. The OZ6912 implements FIFO data
buffer architecture between the PCI bus and CardBus socket interface to enhance data
transfers to CardBus Devices. The bi-directional FIFO buffer permits the OZ6912 to accept
data from a target bus (PCI or CardBus interface) while simultaneously transferring data. This
architecture not only speeds up data transfers but also prevents system deadlocks.
The OZ6912 is a PCMCIA R2/CardBus controller, providing the most advanced design
flexibility for PC Cards that interface with advanced notebook designs.
OZ6912 FEATURES – only Single Slot Solution
•
Supports only one PCMCIA 2.1 and JEIDA 4.2 R2 cards or 2 CardBus cards
•
ACPI-PCI Bus Power Management Interface Specification Rev 1.1 Compliant
•
Supports OnNow LAN wakeup, OnNow Ring Indicate, PCI CLKRUN#, PME#, and
CardBus CCLKRUN#
•
Compliant with the 33Mhz PCI Specification V2.2, 2000 PC Card Standard 7.1 for
OZ6912
•
Yenta™ PCI to PCMCIA CardBus Bridge register compatible
•
ExCA (Exchangeable Card Architecture) compatible registers map-able in memory
and I/O space
•
Intel™ 82365SL PCIC Register Compatible
•
Supports PCMCIA_ATA Specification
•
Supports 5V/3.3V PC and 3.3V Cardbus cards
•
Supports two PC Card or CardBus slots with hot insertion and removal
•
Supports multiple FIFOs for PCI/CardBus data transfer
FIC M295 / M296 Service Manual
4-19