Frymaster DEAN FPD65 - Manual (Page 20)

HIGH EFFICIENCY DECATHLON (HD) SERIES GAS FRYERS
CHAPTER 3: INSTALLATION
3-7
3.5 Gas Specifications
CE ONLY (Altitudes of 2000 feet or less)
EQUIPMENT
PRESSURE MODEL
INPUT
(kW)
GAS
TYPE
ORIFICE
(MM)
ORIFICE
PART NO.
QTY
MBAR INCH W.C.
D20G 15,0
G20
G25
G31 2,40
2,40
1,51 810-2060
810-2060
810-2059 2
2
2 10,0
15,0
27,0 4,0
6,0
10,8
D50G 30,0
G20
G25
G31 2,40
2,40
1,51 810-2060
810-2060
810-2059 4
4
4 10,0
15,0
27,0 4,0
6,0
10,8
D60G 37,5
G20
G25
G31 2,40
2,40
1,51 810-2060
810-2060
810-2059 5
5
5 10,0
15,0
27,0 4,0
6,0
10,8
D80G 37,5
G20
G25
G31 2,40
2,40
1,51 810-2060
810-2060
810-2059 5
5
5 10,0
15,0
27,0 4,0
6,0
10,8
NOTE: Outlet gas pressure must be adjusted strictly within the above requirements 5 to 10 minutes after the appliance is operating.
(Pilot Flame Adjustment: Turn the pilot adjustment screw clockwise/counter-clockwise until the desired flame-volume is achieved.)
3.6 Gas Conversion Procedures
DANGER
This appliance was configured at the factory for a specific type of gas. Converting from
one gas type to another requires the installation of specific gas-conversion components.
Switching to a different type of gas without installing the proper conversion
components may result in fire. NEVER ATTACH THIS APPLIANCE TO A GAS
SUPPLY FOR WHICH IT IS NOT CONFIGURED!
Conversion of this appliance from one type of gas to another should only be
performed by qualified, licensed, and authorized installation or service personnel, as
defined in Section 1.6 of this manual.
Contact factory with the following information when performing conversions:
• Fryer Serial Number
• Fryer Model Number
• Gas Type
• Operating Altitude
Conversions can only be executed by qualified, factory-authorized personnel.
Pressure flow adjustment
(remove cover screw to
access)
ON/OFF
Gas-Cock Knob
Pilot gas supply
connection.
Regulator Vent
Pilot pressure adjustment
(remove cover screw to
access)
Typical non-CE gas valve for electronic-ignition equipped fryers.