Fluke 807-0115 - Manual (Page 22)

N E T W O R K S U P E R V I S I O N
Fluke Networks
P.O. Box 777, Everett, WA USA 98206-0777
Fluke Networks operates in more than 50 countries
worldwide. To fi nd your local offi ce contact details, go to
www.fl ukenetworks.com/contact .
© 2006 Fluke Corporation. All rights reserved.
Printed in U.S.A. 2/2006 2643526 D-ENG-N Rev A
What are ASEs?
ASEs (Analysis Service Elements) are data
collection and network performance monitor-
ing hardware devices placed on a wide area
network (WAN) or Local Area Network (LAN)
as part of the Visual UpTime Select system,
which offers in-depth, real-time, and historical
visibility into the performance of your
applications infrastructure. In the system,
data gathered by ASEs is stored in the Visual
UpTime Select server and displayed and ana-
lyzed from the Visual UpTime Select Web client.
As a service level management tool, ASEs
indicate when services are being met, provide
warnings when services start to degrade, and
send alerts when services are not met.
Hardware Warranties
Enhanced Gold, Bronze, and International
Gold ASE hardware warranty service programs
are available to help you maximize your
investment in Visual UpTime Select. For more
detailed warranty information, visit:
www.fl ukenetworks.com/visualcustomercare
Ordering Information
For more details, please contact your Visual
UpTime Select authorized reseller or
Fluke Networks Sales at (800) 240-4010
or (301) 296-2300.
OC-3c inline probe ASE specifcations
General Dimensions 1 EIA unit (1.75”) high x 19” wide rack-mountable
chassis
Weight 10 lbs.
Data Rate to 155 Mbps synchronous
Timing Mode Derived externally from the network.
Environment Operating Temperature 0
o
to +40
o
C (+32
o
to +104
o
F)
Storage Temperature -20
o
to +55
o
C (-4
o
to +131
o
F)
Clearance Requirement Minimum of 3” (7.62 cm) space on sides.
Operating/Storage Humidity 10% to 90% non-condensing
Power Requirements Input 100 to 240 VAC
Frequency 50/60 Hz
Input Current Rating 0.5 amps
Bypass 5 volt 1 amp DC
Network Interface Line Rate 155.52 Mbps
Line Mode SONET or SDH
Cell Delineation HEC
Cell Scrambler Enable or Disable
Connectors 2 Sff Duplex-LC, Network Tx and Rx, CPE Tx and Rx
Wavelength 1274 nm/1356 nm
Tx Average Output Power -11dBm (typical) Measured with single mode cable
Rx Sensitivity -33dBm (typical)
Serial Port Interface Baud Rate 57600, 19200, or 9600 bps
Parity 8 data bits, no parity
Stop Bit 1 stop bit
Electrical Format EIA RS-232, DTE
Connector 9-pin D, male per EIA-574
Ethernet 10/100BaseT
Interface Bite Rate 10 or 100 Mbps
Connector 8-pin modular jack: RJ-48
Compliant with Bellcore GR-253 CORE and ITE G.957 standards