Connecting at pc-camera mode – FujiFilm 2800 Zoom User Manual

Page 36

●

Do not disconnect the USB cable when the camera
is communicating with the PC. See P.72 for
information on the disconnection procedure.

i The indicator lamp alternately blinks green and

orange while the camera is communicating
with your PC.

i The lens is fixed at the wide-angle zoom

setting.

i “PC CAM” appears on the screen.
i The camera does not automatically switch off

when a USB connection is being used.

i FinePixViewer automatically starts up and the

Picture Hello window opens (Windows only).

i You can use software

such as VideoImpression
to view live images.

Camera Operation

PC Operation

✽ Screen for Windows 98 SE

✽ Screen for Macintosh

If the above operations do not occur, you do not
have the required software programs or drivers
installed on your PC. Refer to the Software
Quick Start Guide booklet and complete the
required PC setup procedures. Then reconnect
the camera to your PC.

CONNECTING AT PC-CAMERA MODE

(USB)
Socket

Camera

(Special USB)
socket

DC IN 5V Socket

1Remove the lens cap.
2Press the “POWER” button to switch the

camera on.

3Set the “USB MODE” setting in the “SET–UP”

menu to “PC CAM” (

➡P.62, 63).

4Press the “POWER” button to switch the

camera off.

1Switch your PC on.
2Use the special USB cable to connect the camera to

your PC.

3Switch the camera on.

Always use the prescribed procedure when
disconnecting or switching off the camera (

➡P.72).

●

You should use the AC power adapter when the camera
is connected to your PC (

➡P.19). Loss of power during

data transmission can prevent successful data
downloading.

●

If you are using Windows XP, you must also refer to the
Software Quick Start Guide booklet.

●

Take care to connect the plugs on the special USB cable
into the correct sockets, and ensure that the plugs are
inserted firmly.

On Windows PCs (excluding Windows XP), if the
“Add New Hardware” wizard appears, close the
wizard and switch off the camera. You must install
the software before connecting the camera to your
PC. (

➡Software Quick Start Guide booklet)