Furuno FCV-1150 User Manual

Page 13

Through-hull mount water temperature/speed sensor ST-02MSB,
ST02-PSB

Select a suitable mounting location considering the following:

• Select a mid-boat flat position. The sensor does not have to be installed perfectly perpendicu-

lar. The sensor must not be located where it might get damaged in dry-docking operation.

• Select a place apart from equipment generating heat.
• Select a place in the forward direction viewing from the drain hole, to allow for circulation of

cooling water.

• Select a place free from vibration.

1. Dry-dock the boat.
2. Make a hole of approx. 51 mm diameter.
3. Unfasten locknut and remove the flange of the sensor.
4. Apply high-grade sealant to the flange of the sensor.
5. Pass the sensor casing through the hole.
6. Face the notch on the sensor toward boat's bow and tighten the flange.
7. Set the sensor section to the sensor casing and tighten the locknut.
8. Launch the boat and check for water leakage around the sensor.

Water temperature/speed sensor ST-02MSB, ST-02PSB

Locknut

123

Face "notch"
toward bow.

Flange nut

Coat with
silicone sealant.

Brim