Frymaster Dean FPHD - Manual (Page 26)

HIGH EFFICIENCY DECATHLON SERIES GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-21
1.7.8 Replacing the Frypot (cont.)
6. Remove the top cap. It is held in place by one screw on
each side of the fryer. If the fryer has a controller on
the front, the top cap may also be held in place by two
screws on the front of each pot. FPHD65 units may
have two screws on each end of the top cap.
7. Remove the joiner strips on either side of the frypot. Be
careful not to bend the joiner strip during removal.
8. Remove back panels of the fryer.
There may be both upper and lower
panels and several screws secure
them. Screw location and orientation
will vary according to fryer model.
9. Remove screw securing brace (and back panel) to the
flue cap. Support the brace with hand while removing
screw to prevent brace from falling away. Remove
brace and set aside for reassembly.
Typical screw locations on the back panel (may vary by
model).
Removing brace holding back panel to flue
cap.
Removing the joiner strip.