Fagor America SHA-730 X - Manual (Page 9)

6 • English
Oven Racks
General Oven Tips
Operating the Oven
C60T266A4 12/1/06 16:51 Página 8
• The oven has rack guides at four levels as shown in the
illustration on page 7 .
Rack positions are numbered from the bottom rack guide
(#1) to the top (#4).
• Check cooking charts for best rack positions to use when cooking.
• Make sure that the racks are level once they are in position.
• The racks are designed to stop when pulled forward to their limit.
• CAUTION! Never use aluminum foil to cover the oven racks
or to line the oven. Heat trapped under the foil can cause
damage to the oven liner.
CAUTION:
To avoid possible burns, place oven
racks in desired positions before turning the oven on.
Always use oven mitts when the oven is warm.
CAUTION: Make sure you do not force it to
avoid damage to the enamel.
To remove oven rack from the oven:
1. Pull rack forward
2. Lift rack up at front and then remove it
To replace an oven rack:
1. Place rear of rack between rack level guides
2. While lifting front of rack, slide rack in all the
way while lowering the front
• The extendable rack allows for easier access to food.
It extends beyond the standard flat rack bringing the
food closer to the user.
Oven Extendable Racks
CAUTION:
When the rack is outside of the oven,
slide arms do not lock. They could unexpectedly extend
if the rack is carried incorrectly.
Extending slide arms
could cause injury. Rack should only be held or
carried by grasping the sides.
To remove extendable rack from the oven:
1.
2.
3.
To replace an extendable rack:
1.
2.
3.
Lift of rack slightly and push it until the stop release
Raise back of rack until frame and stop clear rack guide
Pull rack down and out
NOTE: Always remove the extendable rack before self-
cleaning the oven.
CAUTION! To avoid burns, pull rack all the way out and lift
pan above handle when transferring food to and from oven.
Please refer to illustration on Page 7 if there is any question
as to which side is the front of the rack.
Grasp rack firmly on both sides. Place rack (including
frame) above desired rack guide
Pull both sections forward until stops activates.
Rack should be straight and flat, not crooked
Push all the way in until the back of the rack drops into place