FujiFilm Zoom Date 160ez - Manual (Page 44)

42
Trouble Shooting
Problems Possible Causes Solutions See Page
During operation
The shutter can-
not be released.
After loading the
film and closing
the camera back,
“
´” blinks.
After loading the
film and closing
the camera back,
the film is
rewound and “
´”
is displayed.
The film is
rewound during
photographing.
The picture
counter blinks.
q Is “ ” blinking on
the LCD?
w Doesn’t the power turn
on?
e Is “f” blinking on the
LCD?
r Is “´” displayed on the
picture counter?
t Is the AF lamp blinking in
the q mode?
/Is the film pulled out to
the FILM TIP mark? Is it
pulled out beyond the
FILM TIP mark?
/Did you open the camera
back so as to take out the
film without checking that
the motor has stopped
and that “
´” is dis-
played?
/Did you press the n
button while the film in
mid-roll was loaded in the
camera?
/Did you take out the film
in mid-roll without rewind-
ing?
q Replace with the new
battery.
w Press the POWER button.
e The flash is charging.
Wait until “ f” stops blink-
ing (The flash takes
about 6 seconds to
charge).
r Take out the film, and
load an unused film.
t Taking pictures at 0.65 –
1.3m (2.1 – 4.3ft.) or use
the AF lock so that the
AF lamp lights up.
/Adjust the film length so
that the film tip is at the
FILM TIP mark, and load
the film again.
/Check that the motor has
stopped and that “ ´” is
displayed. After that,
open the camera back
and take out the film.
/Be sure not to press the
n button while the film
in mid-roll is loaded in the
camera.
/After taking out the film,
remove the battery, press
the POWER button, and
check that the picture
counter is no longer dis-
played. Then load the
battery again.
13
13
21
17
39
18
25
26
27