FujiFilm Zoom Date 160ez - Manual (Page 14)

12
2
LOADING THE BATTERY
Your camera requires one 3V lithium
battery, type CR2/DL CR2.
1
Move the battery cover release
knob in the direction of the arrow.
2
Flip open the battery cover.
3
Load the battery, - end first fol-
lowing the instructions shown in
the drawing on the inside of the
battery cover.
Important: Pay careful attention to the polari-
ty of the battery as indicated by the
= and
- signs on the battery. The battery must be
loaded the correct way or the camera will not
work.
4
When the battery is loaded cor-
rectly, close the battery cover by
pressing it until it snaps into place.
If it does not snap into place, do
not force it but recheck the posi-
tion of the batteries.
0 1
0 2
0 3
0 4
/One new lithium battery should be
enough for about 200 pictures (based
on our test conditions).
/When traveling, take extra batteries in
the event the batteries stop working.
This is important if you visit areas where
new batteries may be difficult to get.
/After changing the battery, reset the
date to get the right date/time record-
ing (
➜p.14).
2Do not apply force to the battery cover.